In this shot you can just about see where all the RCS thrusters were hollowed out.
This was done by push forming some slim hollow cones using the metal nib end of an old
propelling pencil and a electric paintstripping heat gun.
Simply put, i cut a hole about 2mm wider than the body of said propelling pencil in some
12mm MDF, stapled some 1mm plasticard to it then used the gun to heat it.
All just judgement but at the point the plastic was soft enough, i just pushed the nib end into it and let it cool.
Repeat as many times as needed for the amount of thruster nozzels and your done.
Glue into place and as near the correct angle as possible, let dry, trim excess,
sand to shape, sorted. I also decided to hollow out the antenna depressions while i was at it.